XVME-9090
Rear Transition Module
 |
Compatible Products |
Overview
The XVME-9090 Rear Transition Module is used to connect an external DVD, CD-ROM or hard drive and the SATA interface to your XVME-6200 module. It has a single edge connector, labeled P2 which connects to the J3 and J5 backplane connectors on the rear of the CompactPCI chassis. A front panel allows for this module to be latched in and screwed in for a secured connection.
The XVME-9090 module has a connector on it for the connection of up to two IDE hard drives, two SATA drives, an optional on-board EIDE or Compact Flash drive and two Communications ports. Pin outs for all of the connectors are in this chapter.
The EIDE1 connector connects one or two standard hard drives, CD_ROM drives and DVD drives. The connector IDE1 uses a standard 80-conductor-40pin EIDE (see jumper JP9) cable. This cable can not exceed a cable length of 12". The optional on-board EIDE or Compact Flash drive connector (IDE_ZIF1) is used to connect to a VME-912 Compact Flash carrier board or a VME-913 1.8" hard drive (consult factory for size). Two SATA drives can be connected to the VME-9090. The Ethernet ports (ETH 0 and ETH 1) can be used if the VME-6200 is in a non-PICMG 2.16 chassis other wise these should not be used. The Jumpers LAN_SEL A and LAN_SEL B enable and disable the rear Ethernet ports.
Compatible Products
| Compatible Products | Description | Model Number |
| XVME Processor | Pentium M 1.0GHz (VR7 Replacement) | XVME-689VR7 |