TPMC630

The TPMC630 is a standard single-width 32 bit PMC module providing a user configurable FPGA with 300,000 system gates. All local signals from the PCI controller are routed to the FPGA.

The TPMC630-10 has 64 ESD-protected TTL lines, the TPMC630-11 provides 32 differential I/O lines using EIA 422 / EIA 485 compatible, ESD-protected line transceivers. The TPMC630-12 provides 32 TTL and 16 differential I/Os. All lines are individually programmable as input, output or tri-state. The receivers are always enabled, which allows determining the state of each I/O line at any time. This can be used as read back function for lines configured as outputs. Each TTL I/O line has a pull-up resistor. The pull-up voltage is selectable to be either +3.3V or +5V. The differential I/O lines are terminated by 120 ohms resistors.

The FPGA is configured by a serial Flash. The Flash device is in-system programmable via driver software over the PCI bus. An in-circuit debugging option is available via an optionally mountable JTAG header (on the backside of the board) for readback and real-time debugging of the FPGA design (using Xilinx "ChipScope").

A programmable clock generator supplies up to six different clock frequencies between 200 kHz and 166 MHz. All outputs are available at the FPGA, one clock source is in addition used as the local clock signal for the PCI controller. The clock generator settings are stored in an EEPROM and can be changed by the driver software through PCI9030 GPIO pins.

The configuration EEPROM of the PCI controller can also be modified by the driver software, to adapt address spaces etc.

User applications can be developed using the design software ISE WebPACK which can be downloaded free of charge from www.xilinx.com.

The TPMC630 provides front panel I/O via a HD68 SCSI-3 type connector and rear panel I/O via P14.